Toyota Avalon (XX50): Television Camera(for Side)
Components
COMPONENTS
ILLUSTRATION
|
*1 | OUTER MIRROR |
*2 | OUTER MIRROR COVER |
|
*3 | SIDE TELEVISION CAMERA ASSEMBLY |
*4 | VISOR HOUSING |
|
*5 | CAMERA COVER |
- | - |
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. INSTALL SIDE TELEVISION CAMERA ASSEMBLY
(a) Using a T10 "TORX" driver, install the side television camera assembly to the camera cover with the 2 screws.
(b) Engage the 3 guides as shown in the illustration.
 |
Install in this Direction |
(c) Engage the 4 claws.
(d) Engage the 3 guides.
(e) Connect the connector.
(f) Engage the clamp.
2. INSTALL VISOR HOUSING
Click here 
3. INSTALL OUTER MIRROR COVER
Click here
4. INSTALL OUTER MIRROR
Click here
5. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER
Click here
6. PERFORM CALIBRATION
for Gasoline Model: Click here
for HV Model: Click here
Removal
REMOVAL
CAUTION / NOTICE / HINT
The
necessary procedures (adjustment, calibration, initialization, or
registration) that must be performed after parts are removed and
installed, or replaced during side television camera assembly
removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model) |
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
- Side television camera assembly LH
- Side television camera assembly RH
| Side television camera view adjustment |
Panoramic View Monitor System |
 |
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model) |
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
- Side television camera assembly LH
- Side television camera assembly RH
| Side television camera view adjustment |
Panoramic View Monitor System |
|
PROCEDURE
1. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER
Click here
2. REMOVE OUTER MIRROR
Click here
3. REMOVE OUTER MIRROR COVER
Click here
4. REMOVE VISOR HOUSING
Click here
5. REMOVE SIDE TELEVISION CAMERA ASSEMBLY
| (b) Insert a 0.9 mm (0.0354 in.) spark plug gap gauge or similar tool into the connector as shown in the illustration.
NOTICE:
- Insert the spark plug gap gauge to the point that the claw becomes the
same height as the protrusion of the connector housing. If the spark
plug gap gauge is inserted too far, or if the claw is lifted directly
using a screwdriver, the claw may be damaged.
- If the claw of the connector is damaged, replace the outer rear view mirror assembly.
|
 |
|
*a | Claw | |
*b | Protrusion | |
*c | Insert Position | | |
(c) Lift the claw and disconnect the connector.
| (d) Disengage the 3 guides. | |
| (e) Disengage the 4 claws. | |
(f) Disengage the 3 guides as shown in the illustration.
 |
Remove in this Direction |
| (g) Using a T10 "TORX" driver, remove the 2 screws to remove the side television camera assembly from the camera cover. |
|
