Installation
INSTALLATION
PROCEDURE
1. INSTALL TELEVISION CAMERA ASSEMBLY
(a) When reusing the television camera assembly:
(1) Engage the 4 claws to install 2 new grommets as shown in the illustration.
|
Install in this Direction |
(b) Connect the connector. | |
(c) Engage the 4 claws to install the television camera assembly as shown in the illustration.
|
Install in this Direction |
2. INSTALL LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Click here
3. PERFORM CALIBRATION (w/ Parking Assist Monitor System)
for Gasoline Model: Click here
for HV Model: Click here
4. PERFORM CALIBRATION (w/ Panoramic View Monitor System)
for Gasoline Model: Click here
for HV Model: Click here
Removal
REMOVAL
CAUTION / NOTICE / HINT
The
necessary procedures (adjustment, calibration, initialization, or
registration) that must be performed after parts are removed and
installed, or replaced during television camera assembly
removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
Television camera assembly (w/ Parking Assist Monitor System) |
- Parking assist monitor system initialization
- Television camera assembly optical axis adjustment (Back camera position setting)
| Parking Assist Monitor System |
|
Television camera assembly (w/ Panoramic View Monitor System) |
- Rear television camera view adjustment
- Television camera assembly optical axis adjustment (Back camera position setting)
| Panoramic View Monitor System |
|
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
Television camera assembly (w/ Parking Assist Monitor System) |
- Parking assist monitor system initialization
- Television camera assembly optical axis adjustment (Back camera position setting)
| Parking Assist Monitor System |
|
Television camera assembly (w/ Panoramic View Monitor System) |
- Rear television camera view adjustment
- Television camera assembly optical axis adjustment (Back camera position setting)
| Panoramic View Monitor System |
|
PROCEDURE
1. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Click here
2. REMOVE TELEVISION CAMERA ASSEMBLY
(a) Disengage the 4 claws to remove the 2 grommets as shown in the illustration.
|
Remove in this Direction |
(b) Disconnect the connector to remove the television camera assembly. |
|