Toyota Avalon (XX50): Telephone And Gps Antenna(for Roof Side)

Components

COMPONENTS

ILLUSTRATION

*1	TELEPHONE AND GPS ANTENNA ASSEMBLY	*2	TELEPHONE AND GPS ANTENNA ASSEMBLY WITH COVER
*3	COVER	*4	WASHER AND HOLDER
*5	SEAL	*6	TELEPHONE ANTENNA HOUSING
	N*m (kgf*cm, ft.*lbf): Specified torque	●	Non-reusable part

Installation

INSTALLATION

PROCEDURE

1. INSTALL TELEPHONE AND GPS ANTENNA ASSEMBLY

(a) When reusing the telephone and GPS antenna assembly:

(1) Install a new seal.

(b) Push the telephone and GPS antenna assembly in the direction indicated by the arrow (1) shown in the illustration to engage the guide.

	Install in this Direction (1)
	Install in this Direction (2)

(c) Push the telephone and GPS antenna assembly in the direction indicated by the arrow (2) shown in the illustration to engage the 2 guides and 3 claws and install the telephone and GPS antenna assembly.

2. INSTALL TELEPHONE AND GPS ANTENNA ASSEMBLY WITH COVER

(a) Temporarily install the telephone and GPS antenna assembly with cover as shown in the illustration.

Install in this Direction

(b) Install a new washer and holder as shown in the illustration.

Install in this Direction

(c) Install the telephone and GPS antenna assembly with cover with the bolt.

Torque:

9.5 N·m {97 kgf·cm, 84 in·lbf}

(d) Connect the connector.

3. INSTALL ROOF HEADLINING ASSEMBLY

Click here

Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during telephone and GPS antenna assembly removal/installation are shown below.

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

PROCEDURE

1. REMOVE ROOF HEADLINING ASSEMBLY

Click here

2. REMOVE TELEPHONE AND GPS ANTENNA ASSEMBLY WITH COVER

(a) Disconnect the connector.

(b) Remove the bolt.

(c) Remove the washer and holder as shown in the illustration.

Remove in this Direction

(d) Remove the telephone and GPS antenna assembly with cover as shown in the illustration.

Remove in this Direction

3. REMOVE TELEPHONE AND GPS ANTENNA ASSEMBLY

(a) Pull the telephone and GPS antenna assembly in the direction indicated by the arrow (1) shown in the illustration to disengage the 3 claws and 2 guides.

	Remove in this Direction (1)
	Remove in this Direction (2)

(b) Pull the telephone and GPS antenna assembly in the direction indicated by the arrow (2) shown in the illustration to disengage the guide and remove the telephone and GPS antenna assembly.

(c) When reusing the telephone and GPS antenna assembly:

(1) Remove the seal.